New Energy Charging Pile maintenance Skills

Author：AronDate：2024-5-27

New Energy Charging Pile Maintenance Skills

1. Electrical fault repair

Electrical failures of new energy mobile charging piles usually include damage to internal electronic components or other electrical problems. When encountering this situation, you can follow the steps below to repair it:

Turn off the power supply of the charging pile to ensure safety;

Open the charging pile shell and check whether there is any obvious damage to the internal circuit board and electronic components;

If it is damaged, you need to purchase corresponding accessories to replace it. If you cannot find the problem, it is recommended to seek help from professional electrical repair personnel.

2. Communication fault repair

Charging pile communication failure usually manifests as a problem with the network connection between the control board and the charging pile, which may affect the remote monitoring and control functions of the charger. The following are the repair methods for communication faults:

Check the network connection of the charging pile. Make sure the network signal is good. If there is any problem, try reconnecting or restarting the router;

Check whether the communication line between the control board and the charging pile is properly connected. If it is loose, re-tighten it;

If the communication problem is still not resolved, it is recommended to contact the charging pile manufacturer for maintenance or replacement.

3. Interface fault repair

Interface failure of new energy mobile charging piles is usually caused by connection problems within the charger port. The following are the repair methods for interface faults:

Check whether the charging interface is clean. If there is dust or other foreign matter, use air pressure or cleaning fluid to clean it;

Check whether the connection port is loose or damaged. If damaged, purchase corresponding accessories to replace;

Make sure the charging cable is tightly connected to the charging interface to avoid loose plugs or poor contact.

4. Daily maintenance and inspection suggestions

In order to extend the service life of the charging pile and ensure safety, the following are some daily maintenance and inspection suggestions:

Regularly clean the charging pile casing and internal circuit boards to avoid accumulation of dust and debris;

Check whether the internal cables are damaged or detached, and repair them in time if necessary;

Check whether the screw holes are loose and keep the equipment stable;

Pay attention to the working status indicator light of the charging pile. If it flashes abnormally or does not light up, please contact the manufacturer in time;

Regularly perform functional checks on the charging pile to ensure that the charging voltage and current output are normal.